Weld Table Accessories
-
TMW 1/2″ Thread Block
$8.50 Add to cartConvert any hole in the table into a 1/2″x 13 threaded hole. Place the Adapter in position beneath the tabletop, in alignment with table holes. Magnets hold threaded adapter in place so you can thread bolts right through from the top of the table!
-
TMW Sliding Stop – 4″ Travel
$8.00 Add to cartMade from 1/4″ A36″ steel, this sliding stop is made for ultimate flexibility. With 4″ of travel, this stop knows no boundaries. Swivel 360 degrees and adjust for the perfect hold! Our Sliding Stop -4″ Travel measures 5.7″ x 2″ x 2″ and weighs 0.81 pounds.
-
BuildPro Fabrication Table 1/2″ Threaded Adapters
$7.80 Add to cartConvert any hole in the table into a 1/2″x 13 threaded hole. Place the Adapter in position beneath the tabletop, in alignment with table holes. Magnets hold threaded adapter in place so you can thread bolts right through from the top of the table!
-
-
TMW Stop Pin
$7.00 Add to cartSecure parts in place with this handy tool. Press fit shank can be inserted in any 5/8-in holes on our tabletop.Measuring: 50x20mmx15.9mm.
-
TMW Mag Block
$6.50 Add to cartMagnets on the bottom of the Magnetic Rest Buttons allow the button to be used at ANY point on the tabletop to elevate workpieces. This part elevates to .5 inch.
-
Beveled Twisted Knot Wire Wheel 5in
$6.49 Add to cartIf you’ve never tried a 5in wheel they offer a LOT more power than a 4.5in wheel and last a lot longer. The bevel allows the twisted knots to angle downward a bit which makes it much more effective!
Even better, in the 10-pack these babies are only $4.50 each! That’s less than half the price you’ll pay anywhere else! 🙂
-
TMW Sliding Stop – 2.5″ Travel
$6.00 Add to cartMade from 1/4″ A36″ steel, this sliding stop is made for ultimate flexibility. With 2.5″ of travel, this stop knows no boundaries. Swivel 360 degrees and adjust for the perfect hold! Our Sliding Stop -3″ Travel measures 4.2″ x 2″ x 2″ and weighs 0.66 pounds.
-
BuildPro Stop
$4.75 Add to cartThis stop can be used wherever parts need to be positively located for clamping. Press fit shank can be inserted in any 5/8-in holes on our tabletop. We offer the 1.5″ tall stop, since it’s by far the most popular with our customers.
-
BuildPro Fabrication Table Magnetic Rest Button
$4.50 Add to cartMagnets on the bottom of the Magnetic Rest Buttons allow the button to be used at ANY point on the tabletop to elevate workpieces. This part elevates to 0.45 inch.
-
Riser Block Family
From: $0.00 Add to cartGain vertical and horizontal space with our new line of Riser Blocks