Customer Reviews

Love these! Glad I got with my order as they have already been needed and used on my first build with your table. Love the fact that I can have on side to widen table or move the to end to lengthen table. I love the flexibility of how many ways they can be used, on the sides, ends or on top if I need a wall. Glad I have them!!!
Only suggestion for these is if you could incorporate the grid pattern you have etched on the table top to continue onto these. Would think not too difficult for programming into CAD when cutting out as you have everything else matching up so well when you are cutting out. But then again I am not a programmer, just a suggestion for future tables and as you grow your company :)

There is no review on the leveling feet I never really got.
I sent an email to John on 6/26/24 following up on the box of what should have been my missing 8" T-clamps and missing leveling feet. I was sent the 300mm T-clamps and leveling feet screws. I received the box broken up and only 3 of the leveling feet were in there, not 6 that my table requires. Again, I never heard back from anyone at Texas metals after sending John this last email.
I am sending you this review as I want to see your company grow and continue. If I can help you get over your growing design pains, it ultimately helps me. I think you have a great welding table design and products to go with it. Your products are helping me give my customers a better quality product where we all win. At the same time, for $9000 I paid, I don't think I should have to be spending the hours I will need to to correct simple design flaws that QC should have caught. Thank you, David Hill

These are great, but as I noted on the 4" sliding stops the hole on the end was distorted and I had to ream out. I then had to square up the front side so that it is square.
These are great with the 1/2" ball pin locks to help set up, be able to move and adjust as a stop and then lock down easily by hand. I had to ream out and square up all 12 of my sliding stops, not 8 as I previously stated. I am slowly filing down the bulge that is created at the crease/bend by the brake. I am doing this so that I have a true flat square plane. Thats just me fine tuning my equipment to my needs.
But I think for the cost and overall order I should not have to ream out all 12 of the 16mm holes.

I like these, I find they dont move the work when setting up like the ratchet clamps do for me. They need to be 1/2' shorter or make your drawers 1/2" deeper so that they can fit in there front to back. To get them to fit into your drawers now I have to lay at an angle which takes up too much wasted space. I discussed this on earlier review.
Also shown on photos I have already submitted.