Specifications

Product Details

TMW leg kits are engineered to support the full range of welding table tops. Heavy wall tubing, precision-cut gussets, and integrated mounting hardware make these legs stable under load and simple to assemble.

Heavy Wall Tubing

Thick-wall square tubing provides rigidity and vibration dampening. No flex or wobble, even under heavy grinding and hammering.

Precision Fit-Up

All components are laser cut and CNC notched for consistent fit. Legs align with the integrated mounting holes in TMW table top rib sections.

Gusseted Corners

Every leg joint includes welded gusset plates for lateral stability. The finished assembly handles racking forces without distortion.

Watch

Leg Kit Overview

Included

Kit Includes

Everything needed to build a complete table base. All components are unfinished steel, ready for welding.

4 leg tubes (pre-cut to length)
Top mounting plates with pre-drilled holes
Bottom foot plates
Cross bracing tubes (front-to-back and side-to-side)
Gusset plates for all leg-to-brace joints
Hardware pack (bolts, nuts, washers for foot attachment)

Options

You Choose

Select the foot type that matches your shop setup.

Leveling Feet

Heavy-duty threaded leveling feet with rubber pads. Best for permanent installations where the table will stay in one location. Provides vibration isolation and allows fine adjustment on uneven floors.

Locking Casters

Heavy-duty swivel casters with brakes. Best for shops that need to move the table for cleaning, rearranging, or sharing floor space. Each caster locks independently for stability during work.

Assembly Guide

Assembly Instructions

The leg kit assembles in three stages. Basic welding skills and standard shop tools are all you need.

1

Assemble the Legs

Lay out all four leg tubes on a flat surface.
Attach the top mounting plates to the upper end of each leg using the pre-drilled holes as alignment guides.
Tack weld the plates square to the legs. Use a combination square to verify 90 degrees.
Attach the bottom foot plates to the lower end of each leg.
Run full weld beads on all plate-to-tube joints.

2

Install Cross Bracing

Stand two legs upright and position a cross brace between them at the designated height.
Tack weld the brace to both legs, then check for square.
Repeat for the opposite pair of legs.
Connect the two leg pairs with the remaining cross braces (front-to-back).
Verify the base sits flat and is square by measuring diagonals.
Weld all gusset plates at the brace-to-leg intersections for rigidity.
Run full beads on all remaining joints.

3

Attach Feet or Casters

For leveling feet: thread the feet into the bottom plates and adjust to level.
For casters: bolt the caster plates to the bottom foot plates using the included hardware.
Verify all four contact points are even. The table should not rock.
Place the assembled base in position and set the table top onto the mounting plates.
Bolt or weld the top to the mounting plates through the rib section mounting holes.

Leg Kit Assembly Instructions (PDF)

Download the complete weldment and table assembly guide with diagrams.

Download PDF

40″x100″ – Welding Table Legs